5.5 CLICKTOLINK® INTERCOM
Click-to-Link is the spontaneous, “social” feature of your scala rider.
Use Click-to-Link to make intercom calls with other scala rider
users near you without pre-pairing.
Click-to-Link can be disabled on your Q3 eectively blocking any
attempt by others to make Click-to-Link calls to you.
If you want to… Perform this action:
Start a CTL call request
(search lasts up to 10 seconds)
In standby, press “MM” for 2 seconds
End a CTL call /
Cancel a CTL call request
Tap “IC”
Accept a CTL call When hearing the CTL ringtone:
Tap “IC” or say any word loudly to
answer by VOX
Reject a CTL call Remain silent until the CTL ringtone
stops or press “IC” for 2 seconds
ENABLE/DISABLE CTL
(Default: ENABLED)
Via the Voice Menu (see section 4.5) or via
the Cardo Community
If other scala rider users are nearby, your next Click-to-Link call
may randomly connect to any of them.
5.6 BUSY SIGNAL
A busy signal will be heard when attempting to establish an
Intercom call with another device that is already on a phone or
intercom call.
6. PAIRING AND USING A MOBILE PHONE,
GPS DEVICE OR MP3 PLAYER
To connect your scala rider to a Bluetooth device you must rst
pair them. Once paired, they will automatically recognize each
other whenever they are within range (10m / 33ft).
Your scala rider has two Bluetooth channels for connection to
mobile phones, GPS devices and music players with A2DP.
6.1 PAIRING BLUETOOTH CHANNELS 1 AND 2
1. Make sure Bluetooth is enabled on your phone/GPS/MP3 player.
2. Check the scala rider is in Standby (single BLUE ash every
3 seconds).
3. To pair Bluetooth Channel 1 – press “V+” for at least 5 seconds
until the RED and BLUE LEDs begin rapidly alternating.
To pair Bluetooth Channel 2 – press “V-” for at least 5 seconds
until the RED and BLUE LEDs begin rapidly alternating.
4. Search for Bluetooth devices on your phone/GPS/MP3 player by
following the device’s instructions.
5. After a few seconds the device will list “scala rider Q3 ”. Select it.
6. If prompted for a PIN or Passkey, enter 0000 (four zeros).
7. The device will conrm that pairing has succeeded and the
scala rider will begin ashing slowly in BLUE.
8. If Pairing is not completed within 2 minutes, the scala rider will
return to Standby mode.
scala rider
®
Q3 / Q3 MultiSet™ |
9
scala rider
®
Q3 / Q3 MultiSet™ |
9
Comments to this Manuals