Cardo Q3 MultiSet User's Guide download pdf (Page 6)

4. GETTING STARTED

4.1 GENERAL FUNCTIONS

Power ON / OFF Press “IC” for 2 seconds

ON: 3 BLUE ashes + Ascending tone

OFF: 3 RED ashes + Descending tone

Volume Tap “V+” or “V-” to adjust and set volume of

current audio source

Mute Tap “V+” and “V-” simultaneously

Battery Check In Standby, press “V+” for 2 seconds:

• BLUE LED = Full charge

• PURPLE LED = Half charge

• RED LED = Almost empty

Voice Menu In standby, press “MM” and “IC” simultaneously

for 5 seconds and follow the audio instructions

(see section 4.5)

Enable / Disable

VOX (For Intercom

calls only)

In standby, press “V+” and “V-” simultaneously

for 2 seconds

ENABLED: Blue ash for 2 seconds

DISABLED: Red ash for 2 seconds

Enable/Disable

Click-to-Link (CTL)

(Enabled by default)

Via the Voice Menu or via the Cardo Community

Enable/Disable

Spoken Status

Announcements

(Enabled by default)

Via the Voice Menu or via the Cardo Community

4.2 STATUS LIGHTS

None scala rider is OFF

1 BLUE ash every 3 seconds Standby mode

No active audio sources

2 BLUE ashes every

3 seconds

Active mode – Call in progress / music

or other audio source is ON

1 RED ash every 3 seconds Standby mode – Battery is low

2 RED ashes every 3 seconds Active mode – Battery is low

Solid RED Charging

4.3 AUDIO SOURCES AND PRIORITIES

If two connected audio sources try to play audio simultaneously, your

scala rider automatically determines which audio source to play

through the speakers based on the priority of the connected devices.

Higher Priority

1. Mobile Phone audio or GPS instructions*

2. Intercom / Click-to-Link

3. A2DP (Stereo Bluetooth) audio

4. FM Radio (Built-in)

5. AUX (for corded connection i.e. Music Players)

* GPS instructions from Smartphone GPS Apps are

prioritized like A2DP audio



Lower Priority

For example:

• Incoming mobile phone calls interrupt ongoing intercom calls

• Incoming intercom calls will interrupt ongoing A2DP music

• Intercom and Click-to-Link calls have the same priority. So

Click-to-Link calls will not interrupt any Intercom call in progress,

and vice-versa.

NOTE:

A2DP audio priority can be congured to be higher than

Intercom audio priority via the Cardo Community (see section 4.4).

| scala rider

Q3 / Q3 MultiSet™

| scala rider

Q3 / Q3 MultiSet™

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Comments to this Manuals

No comments

Cardo Q3 MultiSet User's Guide Page 6

Comments to this Manuals